Download Web Browser Interface User's Guide

AT-S63 Management Software Web Browser Interface User’s Guide
v2c
Select this value to associate the Group Name with the SNMPv2c
protocol.
v3
Select this value to associate the Group Name with the SNMPv3
protocol.
6. In the Security Name field, enter the User Name to be associated with
a group.
Enter a User Name that you configured in “Creating a User Table
Entry” on page 226.
7. In the Group Name field, enter a Group Name that you configured in
the Access Table.
See “Creating an Access Table” on page 240.
There are four default values for this field that are reserved for
SNMPv1 and SNMPv2c implementations:
ˆ
defaultV1GroupReadOnly
ˆ
defaultV1GroupReadWrite
ˆ
defaultV2cGroupReadOnly
ˆ
defaultV2cGroupReadWrite
8. In the Storage Type field, select one of the following storage types for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the SecurityToGroup Table. After making changes to a
SecurityToGroup Table entry with a Volatile storage type, the Save
Config option is not displayed on the Configuration menu.
NonVolatile
Select this storage type if you want the ability to save an entry in the
SecurityToGroup Table. After making changes to a SecurityToGroup
Table entry with a NonVolatile storage type, the Save Config option is
displayed on the Configuration menu. Allied Telesyn recommends this
storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 SecurityToGroup
Table entry takes effect immediately.
9. Click Apply.
Section III: SNMPv3
249