1
Download CNC 8055 - Installation manual
Transcript
I n st a l l a t io n ma n u a l 15.1 Configuration file It is a program which describes the operating characteristics of the graphic elements of the screen. Set g.m.p. "CFGFILE (127)" with the number of the program for the configuration file: The configuration file is a CNC program edited in high level language (configuration language) which is described later on. It may be edited both at the CNC and at a PC. Configuration file CUSTOMIZABLE SCREENS 15. It may be in the user RAM and in the hard disk (KeyCF). If it is in both places, the one located in user RAM will be used. It is recommended to store it only in the hard disk (KeyCF) once it has been fully debugged. The configuration file must contain all the information regarding all the screens being customized. When editing a screen, the CNC overlaps the OEM screen over the standard CNC screen. The DISABLE instruction of the configuration file serves to indicate which of the standard screen areas are eliminated. Example: Standard screen + OEM screen + Disable 1 Standard screen OEM screen Both screens are overlapped; but "Disable 1" indicates that the area 1 of the standard screen is not displayed. Therefore: Next, all the screens that may be customized will be shown and the nomenclature to be used in the configuration file. Numbers 1, 2, 3, 4 and 5 indicate the areas each screen is divided into. CNC 8055 CNC 8055i [JOG] JOG mode - Actual SOFT: V01.6X ·570· [JOGAFL] JOG mode - Actual and Following error
