Download User manual

Setup wizard
HDD Management
1.
6.
To transfer this schedule to other cameras, first select the camera (or “All” if all cameras should have
the same settings) and confirm by pressing Copy.
7.
Exit the setting by pressing OK, then click on Next.
Click on “Enter”.
Network Settings
1.
2.
Click on “Enter”.
To set up a new HDD, tick the box and then click on
Init.
Warning
All data on the drive is deleted!
Note
3.
Confirm the prompt by pressing OK. The HDD is
then set up for operation. The progress is displayed
on the status bar.
4.
Exit the setting by pressing OK, then click on Next.
To check whether DHCP can be selected (or if
you have to set the IP address and other settings
manually), consult your network administrator.
2.
DHCP activated: If DHCP is set up in the network
router, then tick the DHCP box. All network settings
are then made automatically.
3.
DHCP not activated: Enter the data manually (IP
address, subnet mask and default gateway = IP address of the router).
Record Settings
1.
Click on “Enter”.
A typical address specification is as follows:
4.
2.
Select the camera in the “General” tab and specify
the settings.
3.
Click on the “Schedule” tab and then on Edit.
4.
Tick the “Enable Schedule” box and All Day. Recording is then switched on for the entire day.
5.
Exit the setting by pressing OK. The settings are
displayed in colour in the schedule overview.
·
IP address:
192.168.0.50
·
Subnet mask:
255.255.255.0
·
Default gateway:
192.168.0.1
·
Preferred DNS server:
192.168.0.1
Exit the setting by pressing OK, then click on Next.
17