Download OPERATORS MANUAL

As you can see from the previous two pages there are many different ways to control faders within the console.
There is no right or wrong way and the best method will depend largely on the specific application and the user
preference. It is quite likely that the method chosen will change with time as the user gains more confidence in
the system the performance becomes more regular and rehearsed. The following recommendations are intended
as a guide only:1. REAL FADER STORE AND RECALL MODES
Used for initial set up of a show and during early rehearsals. Also used for situations where no prior setup has
been possible. Fader positions stored to the automation memory are as per the real faders so great care must be
taken to set them correctly prior to overstoring any adjustments.
2. VIRTUAL FADER STORE MODE
Used for later rehearsals and for shows where there is a large degree of change from night to night due to venue
conditions or add lib's etc. Each scene recalled is as it was stored but may need adjustment to suit the prevailing
conditions. Adjustments are clear and fast to implement with the real fader taking over from the virtual fader as
required. Overstoring is easily possible so as to fine tune the data stored in the automation memory.
3. VIRTUAL FADER RECALL MODE
Used for events and shows that are well rehearsed and predictable. Each scene recalled is as it was stored plus
an offset adjustment from the real fader if required. Any adjustments that are made are active for all subsequent
scenes until such time as they are removed by the operator. Overstoring is not possible.
39