Download Operating instructions DIM MULTieco

A
max
1
2
3
Deactivating presence detection via ...
pushbutton
Operation (cont.)
B
Note: Function is locked if necessary, see “Locking and releasing pushbutton functions”.
1
2
min
min
Switch on if necessary.
‚Double-click.
ƒConfirmation: Luminaire switches off. Green LED on the
+ 15 s
2
1
2
min
+ 15 s
Locking and releasing pushbutton functions
+ 15 s
Lock preset reference and deactivation of the presence
detection
1
2
Set the minimum brightness and press the pushbutton for
1
2
min
max
max
1
min
+ 15 s
Lock the preset reference and manual brightness change
+ 15 s
+ 15 s
1
2
Re-release all pushbutton functions
> 30 s
Press the pushbutton for 30 seconds.
max
2
2
3
1
< 30 s
2
3
Note: When the presence detection is activated, each time a
movement is detected, the countdown of the time restarts.
Turn the adjusting screw to the required setting:
60
min
10 s
1
Adjusting the switch-off delay time
5 15 30
1
2
‚Confirmation: Luminaire flashes.
2
+ 15 s
> 30 s
< 30 s
another 15 seconds.
‚Confirmation: Luminaire flashes.
> 30 s
1
2x
Set the maximum brightness and press the pushbutton for
2
2
1
another 15 seconds.
‚Confirmation: Luminaire flashes.
+ 15 s
1
1
1
sensor lights continuously.
The presence detection is activated again the next time the
luminaire is switched on by pushbutton if presence detection is
switched on and active through selection of the corresponding
operating mode.
2
1
2x
Deactivate presence detection:
+ 15 s
1
min
When presence detection is active, the green LED on the
sensor lights up briefly each time motion is detected.
3
• To the left: shorter (min. 10 s)
time
• To the right: longer (max. 60 min)
2
Behaviour after a power failure
A
max
1
2
3
1
2
3
1
< 30 s
2
3
1
2
3
1
2
3
A
After a power failure, the luminaire remains switched off until
the next time presence is detected or a pushbutton is operated.
max
2x
B
...
B
...
If the “Automatic switch-off” function is switched on in the
“Brightness reduction” operating mode, the luminaire switches
on with the standby value after a power failure.
A
max
1
2
3
B
1
2
...
3
Page 3 of 4