Download 602-0199-01
Transcript
11. Route the SA Module Harness’s “Steering Wheel Encoder” cable up from the SA Module on the right, rear side of the cab, and into the cab at the wire access port as shown in Figure 6-30. 12. Feed the cable along the bottom of the side console and up towards the front of the cab. Note: Ensure the cable will not be damaged by moving parts in the route it is placed, especially where the vehicle pivots when steered. Figure 6-30 Route Steering Wheel Encoder Cable into Cab Steering Wheel Encoder Cable 13. Route the “Steering Wheel Encoder” cable from the side console to the steering wheel console along the existing wire guide as shown in Figure 6-31. Figure 6-31 Route Steering Wheel Encoder Cable to Steering Wheel Console Steering Wheel Encoder Cable Hardware Installation Guide 71