Download 602-0271-01
Transcript
Installation Procedure 9. Refer to the ParaDyme system cable diagram (see Figure 3-1) to complete the cable installation. Connect the 4-pin connector on the SAM harness to the proportional valve adapter cable. Figure 3-7 Connect the 4-Pin Connector 10. Connect the 10-pin connector on the SAM harness to the other adapter cable used. Figure 3-8 Connect the 10-Pin Connector 11. Refer to the ParaDyme vehicle-specific Hardware Installation Manual to install the Roof Module, Display, SA Module and Wheel Angle Sensor (when used). Hardware Installation Manual 15