Download 602-0271-01

Transcript
Installation Procedure
9. Refer to the ParaDyme system cable diagram (see Figure 3-1) to complete the cable installation. Connect the 4-pin
connector on the SAM harness to the proportional valve adapter cable.
Figure 3-7
Connect the 4-Pin Connector
10. Connect the 10-pin connector on the SAM harness to the other adapter cable used.
Figure 3-8
Connect the 10-Pin Connector
11. Refer to the ParaDyme vehicle-specific Hardware Installation Manual to install the Roof Module, Display, SA Module and
Wheel Angle Sensor (when used).
Hardware Installation Manual
15