Download User Manual

POLARIS REMOTE
POLARIS II Remote
5.
Installation
Installation
We recommend setting up the complete system under laboratory conditions and testing
it before it is permanently installed. If a long connection cable is not available, please
use a patch cable to test the basic functions.
DANGER
Electrostatic charging through a stream of particles.
There is a risk of fatal injury in an explosive atmosphere!


5.1
Make sure there are no highly energetic charging mechanisms at the user
interface on the display unit or its accessories.
Do not install the device in the stream of particles.
Requirements
−
The surface underneath and the fastening means for the supporting system must be
designed to support the weight of the POLARIS (approx. 17 kg).
−
Choose the optimum height for operating the POLARIS.
−
Ensure good lighting conditions for a perfectly legible display (no direct exposure to
the sun’s rays).
−
Do not mount in direct proximity to switching or current changing devices.
−
Do not install the device in the stream of particles.
−
The POLARIS must be integrated in the equipotential bonding.
−
At ambient temperature below 0 °C, the POLARIS has to be heated (Heating on
request).
−
Below +10°C the POLARIS needs to be heated to maintain the lifetime of the
backlight illumination.
−
The supply and data line(s) are laid in the supporting system.
−
The supporting system is fastened by means of the flange plate (see the following
illustrations).
Technical data subject to change without notice.
07/2012
15/38