Download OpenPowerNet User Manual

Transcript
OPN/51/1.2.2
Page 166 of 168
User Manual
Issue 2010-05-12
Second the radius r of the circular cross section needs to be multiplied with factor a to get
the equivalent radius req .
req = a ⋅ r
a
conductor type
solid cylindrical
0.779
Al and Cu cables, 7 cores, 10-50mm²
0.726
Al and Cu cables, 19 cores, 70-120mm²
0.758
Al and Cu cables, 37 cores, 150-185mm²
0.768
Al and Cu cables, 61 cores, 240-500mm²
0.772
Al and Cu cables, 91 cores, 625-1000mm²
0.774
1 layer Al/Fe cables, 16/2.5 – 300/50mm²
0.55
1 layer Al/Fe cables, 44/32 – 120/70mm²
0.7
2 layers Al/Fe cables, 26 cores, 120/20 – 300/50mm²
0.809
2 layers Al/Fe cables, 30 cores, 125/30 – 210/50mm²
0.826
3 layers Al/Fe cables, 54 cores, 380/50 – 680/85mm²
0.810
Table 17 Factors to calculate equivalent radius from circular cross section radius. Source: H. Koettnitz, H. Pundt;
Berechnung Elektrischer Energieversorgungsnetze; Band I; VEB Deutscher Verlag für Grundstoffindustrie (1968);
Page 230.
7.5
How to draw a constant current?
You need to define a course in OpenTrack and use it with an itinerary for the tracks you want
to check. In the OpenPowerNet Project-File you need to set the attribute
constantCurrent_A to the constant current value you want, see the XML snippet below.
<Propulsion
constantCurrent_A="2000" This attribute defines the constant current for the engine to 2000A.
You can change the value to whatever reasonable value you need. The following attributes will
be ignored once you set this attribute.
brakeCurrentLimitation="I=f(U)"
engine="electric"
fourQuadrantChopperPhi="none"
regenerativeBrake="maxPower/maxEffort"
supply="DC 600V"
tractiveCurrentLimitation="I=f(U)"
tractiveEffort="maxPower/maxTractEffort"
useAuxPower="true">
<EfficiencyTable/>
</Propulsion>
7.6
How to simulate short circuits?
You need to define a course in OpenTrack and use it with an itinerary for the tracks you want
to check. In the OpenPowerNet Project-File you need to set the attribute
shortCircuitEngine to true, see the XML snippet below.
<Propulsion
shortCircuitEngine="true" This attribute defines the engine as a short circuit between the
contact wire and the rail. The following attributes will be ignored once you set this
attribute.
brakeCurrentLimitation="I=f(U)"
IFB DD, UM_OPN_51_01.02.02.doc
Page 166 of 168
DMJ, 2010-05-12