Download EasyScope User Manual

Transcript
20
EasyScope User Manual
To display the delta as a frequency, click on the highlighted display area.
The cursor information panel will now display the delta as frequency instead of time. In this case the
frequency is 2,000 Hz.
The following example uses the time measurement cursors to measure the frequency of the
calibration reference output of a DS2000 oscilloscope. Cursor 1 is placed on the first falling edge of
the waveformand Cursor 2 is placed on the next falling edge of the waveform.
Looking at the cursor information panel ( in frequency mode ), we see that the frequency of the signal
is in fact 1,000Hz or 1.0KHz.
An alternative to using the lower panel buttons is to click on the "Cursors" setting in the top menu
and click on the item you wish to enable or disable.
© 2003 ... USB-Ins truments.c om