Download User Manual - data

B.2 GPIO Sample Code
The SCH3114 Runtime base I/O address is 600h
.model small
.486p
.stack 256
.data
SCH3114_IO EQU 600h
.code
org 100h
.STARTup
;====================================================
; Configuration GPIO as GPI or GPO by below register:
; GPIO0 = 23H, GPIO4 = 27H
; GPIO1 = 24H, GPIO5 = 29H
; GPIO2 = 25H, GPIO6 = 2AH
; GPIO3 = 26H, GPIO7 = 2BH
; Set 00H as output type, set 01H as input type
;====================================================
;====================================================
; Register 4BH configuration GPO value as high or low:
; 1 = HIGH
; 0 = LOW
;====================================================
mov dx,SCH3114_IO + 23h ;GPIO 0
mov al,00h
;Set GPIO 0 as output type
out dx,al
mov dx,SCH3114_IO + 4Bh
mov al,01h
;Set GPIO 0 as high value.
out dx,al
.exit
END
67
MIO-2261 User Manual
Data Modul AG - www.data-modul.com
Appendix B WDT & GPIO
;WD timer counting = 0
;====================================================
mov dx,SCH3114_IO + 68h
mov al,01h
out dx,al
.exit
END