Download User Manual - Solar

6 Installation
Installing the wall mount and hanging the
inverter
• Mark the positions of the drill holes at the installation
site by using the wall mount as a drilling template.
1
2
100
1.
42
6.2 Electrical connection
DANGER
Risk of death due to electrical shock!
If exposed, voltage-carrying cables make contact, an
electrical arc can occur, posing a life-threatening hazard.
• Only remove as much of the cable insulation as is
necessary. The insulation must reach up to the terminal.
200
DANGER
15
Risk of death due to electrical shock!
Metal slivers can fall into the inverter when removing the
insulation. Contact with voltage-carrying components
during operation can cause an electrical arc to occur,
posing a life-threatening hazard.
• Never remove the cable insulation above the
inverter!
max.10°
42
100
104
200
2.
Opening the housing
3.
• Release the four screws of the cover and carefully
remove the cover.
1
2
100
1.
• Unscrew the cable screw connection for the mains
cable (1 in figure 10).
200
45
6.3 Connecting the AC side
20
max.10°
45
100
74
200
2.
1
3.
Fig. 9: Installing the inverter (top:
convert 3T/3.5T/4T/6, below: convert 7T/8T/10T)
1
2
Required space for cooling
Outer dimensions of the inverter
• Drill holes and insert wall anchors if necessary.
• Screw the wall mount to the intended surface.
Use the supplied screws.
Fig. 10: Connections on the housing
1
Cable screw connection for mains cable
• Press the blind plug and the sealing ring out of the
screw connection from the inside towards the
outside using a screwdriver or similar implement.
Detach the sealing ring from the blind plug.
• Hang the inverter on the wall mount.
• Fasten the inverter on the underside using the
supplied screw.
16
Installation and Operating Manual for convert Solar Inverter