Download T8 Manual
Transcript
Installation 3.5 3.5.1 Connecting T8 Spot reading with the INFIELD7 handheld The T8 is fitted with an 8-pin plug. The plug can be connected to an INFIELD7 handheld measuring device. The INFIELD7 displays and stores the soil water tension, the soil temperature and the filling status. 3.5.2 Connection to a data logger For connecting T8 to a data logger or any other data acquisition devices connecting and extension cables are required. Find T8 cables in the chapter “Accessories”. The supply voltage does not has to be stabilized. If the Tensiometer is not permanently powered the warm-up before a measurement should be at least 10 seconds. The Tensiometer plug should be covered with the supplied protective cap anytime the T8 is not connected to an extension cable. Never connect the signal outputs of the T8 to a supply voltage source! The supply voltage must not exceed 18 VDC. Tightly screw together all plugs of connecting cables (CC-8/...) or extension cables (EC-8/...). Do this again after a few minutes as only then the connections will be absolutely water proof. 23/56