Download MVME162BUG 162Bug Debugging Package User's Manual
Transcript
Test Descriptions Internal Loopback - ILB Verifies that the 82596 can be operated in the "Internal Loopback" mode. The 82596 has three modes of loopback: Internal Loopback, External Loopback with the LPBK pin activated, and External Loopback with the LPBK pin not activated. The LPBK pin is connected to the accompanying Ethernet Serial Interface (ESI - 82C501AD) chip. The ESI is then connected to the pulse transformer (PE64102), which in turn is connected to the Ethernet Connector. 3 In Internal Loopback mode the 82596 disconnects itself from the serial link and logically connects TXD to RXD and TXC to RXC. The TXC frequency is internally divided by four during internal loopback operation. The test sets up a data packet (incrementing data pattern) to be transmitted, transmits it, and waits for the reception of the data. Once the data is received, the data is verified to the data transmitted. This transmit to receive loop is performed 32 times. Use the CF LANC command to change the loop count. Command Input: 162-Diag>LANC ILB Response/Messages: After the command has been issued, the following line is printed: LANC ILB: Internal Loopback...................... Running ---> If all parts of the test are completed correctly, then the test passes: LANC ILB: Internal Loopback...................... Running ---> PASSED If any failures occur, the following is displayed (more descriptive text then follows): LANC ILB: Internal Loopback...................... Running ---> FAILED (error message) Once the data packet has been set up to be transmitted, the test instructs the 82596 (through the Command Unit) to transmit the data packet. This failure is the result of the 82596 completing with a transmit data error. The status bits of the error message display indicate the source of the problem: TRANSMIT Command Completion Status Error: OK-Bit =0, ABORT-Bit =0, STATUS-Bits =0010 3-114 162Bug Debugging Package UserÕs Manual