Download User Guide

User Guide CCM-BOOGIE • High Performance CoreTM 2 Duo 3U CompactPCI® CPU Board
Rear I/O Options
Optionally, the CCM-BOOGIE can be used for rear I/O with respect to the following functions:
•
•
•
•
•
•
Analog Graphics
1 Gigabit Ethernet Port
3 SATA Ports
3 USB Ports
Keyboard, Mouse
COM1 (TTL Level)
The pin assignment of the rear I/O connector J2 is chosen to be plugin compatible with EKFs CPU
board CCD-CALYPSO and CCG-RUMBA, thus consistent with the rear I/O module CCT-RIO.
The analog graphics and the gigabit ethernet port 1 signals are routed to multiplexers on the CCMBOOGIE. These switches, controlled by BIOS, select either the front panel or the rear I/O connection.
The COM1 port does not include the physical transceiver (TTL level only). This transceiver is located on
the rear I/O module CCT-RIO instead.
The CCM is also available in versions suitable for a 64-bit CompactPCI backplane. However, the J2/P2
pin assignments of a 64-bit CPCI backplane differ substantially from a CompactPCI rear I/O backplane.
To use the rear I/O feature the system in use must be equipped with a P2 CompactPCI rear I/O
backplane. If the system is provided with a P2 CompactPCI 64-bit backplane instead, several of the
CCM rear I/O signals will collide with the 64-bit address/data lines on the backplane, with
unpredictable results regarding the rear I/O signal integrity.
Single Slot Rear I/O Backplane EKF Part No. 932.4.01.080
© EKF
-47-
ekf.com