Download e-Writer User's Guide
Transcript
Chapter 4. Introduction to HOPE3000 – Smart Programming Function For the detail of “Programming Range Select Window”, please refer to the section “Programming Range Select Window” on this chapter. △ “User Specified Data” — This setting appeared when selecting “User Specified Data”. After clicking the button “Setting”, the “User Specified Data Setting Window” is popped up (as in Fig. 4-9). For the detail of “User Specified Data Setting Window”, please refer to the section “User Specified Data Setting Window” on this chapter. Section Message and Other Information As in Fig. 4-5, this section is divided into three parts: Message Show the execution result of any operation or the e-Writer status. Progress Bar Show the progress when setting writer or doing auto-programming. Execution Time Show the time cost to execute the commands related to e-Writer (like “Set Writer”, “Auto” or others). This information usually is used to measure the programming time. Fig. 4-5 Programming Range Select Window This window is used to select the programming range and it’s divided into the following two modes by “Select mode”: (A) List Mode As in Fig. 4-6, this mode is for the application on the smaller programming range. It is classified as below by interface: 36