Download e-Writer User's Guide

Transcript
Chapter 4. Introduction to HOPE3000 – Smart Programming Function
For the detail of “Programming Range Select Window”, please refer to the section
“Programming Range Select Window” on this chapter.
△ “User Specified Data” —
This setting appeared when selecting “User Specified Data”. After clicking the button
“Setting”, the “User Specified Data Setting Window” is popped up (as in Fig. 4-9).
For the detail of “User Specified Data Setting Window”, please refer to the section “User
Specified Data Setting Window” on this chapter.
Section Message and Other Information
As in Fig. 4-5, this section is divided into three parts:
Message
Show the execution result of any operation or the e-Writer status.
Progress Bar
Show the progress when setting writer or doing auto-programming.
Execution Time
Show the time cost to execute the commands related to e-Writer (like “Set Writer”, “Auto” or
others). This information usually is used to measure the programming time.
Fig. 4-5
Programming Range Select Window
This window is used to select the programming range and it’s divided into the following two
modes by “Select mode”:
(A) List Mode
As in Fig. 4-6, this mode is for the application on the smaller programming range. It is classified as
below by interface:
36