Download User Guide

Figure 69
12.1.1. Setting the type of survey
You can change the grid parameters that you already entered as described in
paragraph 3.4, page 46.
In the case of mapped survey mode, you can redefine your grid. This will change the
coordinates of every position acquired in your survey. You should only use this
feature if you set up invalid grid information in the G-858 magnetometer before
doing your survey, such as invalid line or mark spacing.
In the “Sensor type” combo box choose the configuration of your sensor(s):
12.1.1.1.ONE SENSOR (1 OR LEFT OR TOP OR
FRONT)
You had one sensor only, and it was connected to the first connector.
12.1.1.2.ONE SENSOR (2 OR RIGHT OR BOTTOM OR
BACK)
You had one sensor only, and it was connected to the second connector.
12.1.1.3.HORIZONTAL GRADIENT (RIGHT - LEFT
WHEN WALKING ACCORDING TO
“FORWARD” DIRECTION)
You had two sensors (second sensor on the right of the first sensor).
168