Download MD4 USER'S GUIDE 1.1 Contents

1.2 Connections
E
D
C
B
A
Follow the following steps to connect the system:
1- Install MD4 device onto the vehicle.
2- Connect the Power loom (C-004-0001) to connector A on the rear of the
device. (Attention: tighten with your hands is enough)
3- Connect the analog input loom (C-004-0005) to connector C on the rear of
the device. (Attention: tighten with your hands is enough)
4- Connect the GPS antenna (A-000-0000) to connector D on the rear of the
device. (Attention: tighten with your hands is enough). See section 1.2.1.
5- If present, connect the RPM loom (C-004-0002) to the Power loom (C-0040001).
Attention: the RPM loom is different according to the type of use.
6- If present, connect the TPS loom (C-004-0006) to the analog loom in
input #1 (C-004-0005).
Attention: the TPS loom is different according to the type of use.
7- Connect the 2 wires of the Power (see Power label on it) to the motorcycle
battery (see section 1.2.2).
8- On the left of the device, there is the USB port for PC connection.
Axiogroup srl - via ponticelli,134 – 36020 - Agugliaro Italy
Tel. +39 0444 89 21 49 - Fax +39 0444 89 28 14
E-mail: [email protected] - Web: www.getdata.it
2