Download Operating Instructions - Stoewer

Operating Instruction
K Series
Contents
Contents
1
How To Use This Manual....................................................................................
5
2
Unit Designation...................................................................................................
2.a Detailed unit designation.................................................................................
2.b Nameplate unit designation.............................................................................
6
6
7
3
Part List of Standard Type Gear Units................................................................
3.a K.00.. Type...................................................................................................
3.b K.01.. Type...................................................................................................
3.c K.02.. Type..................................................................................................
3.d K.03.. Type..................................................................................................
8
8
9
10
11
4
Thinks to Check Before the Gear Unit or Geared Motor is Installed..............
4.a Safety notes...................................................................................................
4.b Transportation...............................................................................................
4.c Storage.........................................................................................................
12
12
13
13
5
Installing The Gear Unit......................................................................................
5.a Before you start.............................................................................................
5.b Check Name Plate........................................................................................
5.c Check the ambient conditions and temperature..............................................
5.d Check fitting elements and the shaft dimensions to fit.....................................
5.e Check the voltage supply...............................................................................
5.f Check the mounting position..........................................................................
5.g Use the breather plug.....................................................................................
5.h Check the oil level..........................................................................................
5.i Check shaft ends and mounting faces..............................................................
5.j Cover abresive ambient..................................................................................
5.k Check accessibility to filling, breather and drain plugs......................................
14
14
14
14
14
16
16
16
17
17
17
17
6
Mechanical Installation........................................................................................
6.a Installing gear units in category II2G/D-II3G/D...............................................
6.b Fittting outputshaft elements...........................................................................
6.c Correct position of otputshaft elements.........................................................
6.d Installing customer shaft with shoulder.............................................................
6.e Installing customer shaft without shoulder........................................................
6.f Disassembling customer shaft with shoulder.....................................................
6.g Disassembling customer shaft without shoukder...............................................
6.h Shaft tightening torques...................................................................................
6.i Covering all turning parts................................................................................
6.j Recommended shaft dimensions and disassembling nut dimensions...................
6.k Assembling customer shaft with shrinkdisc.......................................................
6.l Disassembling customer shaft with shrinkdisc...................................................
6.m Assembling gear unit with torque arm...............................................................
18
18
19
19
20
21
22
23
24
24
25
26
28
29
Stöwer Antriebstechnik GmbH
03