Download Operating Instructions RR 22-2

Keep turning the body until its groove engages in the guide block [63] on the
intermediate ring. Then, slide against the intermediate ring and tighten by means
of the head cap screws [71] with the compression springs [73] which are to be
inserted through the holder bores.
By sliding back the ball bearing housing 18 (closing of the head) and sliding the
housing forward again (opening of the head) check for correct engagement in
locking position and entirely free movement of the guide collar on the body after
disengagement from locking position.
For details on the scroll and the insertion of the roll holders see paragraph 2.
38