Download NuTone QTN110E Instructions / Assembly

MODEL QTN110E
Page 3
INSTALL HOUSING & DUCT
CONNECT WIRING
1. Bend
housing
tabs.
Useapliersto
bendhousing
TABSoutto900.
2. Mount
housing to
joist.
TABS
SPACER
(useformountingtoI-Joist)
Holdhousing
inplacesothat
thehousing
tabscontactthe
bottomofthe
joist.Thehousingmountswith
I-JOIST
four(4)screwsor
nails.Screwornailhousingtojoistthroughlowestholesin
eachmountingflange,thenthroughhighestholes.NOTE:
MountingtoI-JOIST(shown)requiresuseofSPACERS(included)betweenthehighestholeofeachmountingflange
andtheI-joist.
5. Connect electrical wiring.
3. Attach
damper/duct
connector.
Snapdamper/
ductconnector
ontohousing.
Makesureconnectorisflushwith
topofhousingand
damperflapfalls
closed.
4. Install
4-inch
round ductwork.
Connect4-inch
roundductwork
todamper/duct
connector.Run
ductworktoa
roofcaporwall
cap.Tapeall
ductworkconnectionstomakethemsecureandairtight.
Run120VAChousewiringtoinstallationlocation.Use
properULapprovedconnectortosecurehousewiringto
wiringplate.Connectwiresasshowninwiringdiagrams.