Transcript
ASSEMBLY INSTRUCTION 74265-89 Note: Please consult a qualified electrician if you are not certain of the installation CAUTION: Before starting the installation, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 1. Strip 3/4” of insulation from wire ends. Twist stripped ends together with pliers black to black and white to white. Snip ends. Attach copper wire to ground wire. Attach wire nuts. Tap nuts and wires together. 2. Insert all wires into the post and mount fixture on top. 3. Tighten screws until the fixture head is secured to the post. 4. Thread long nipple into fixture body. Install glass shade onto fixture body. 5. Install light bulbs. Use only the specified type bulbs and maximum rated wattage or less.(bulbs not included) 6. Place the metal ring, cap and roof over the long nipple and use finial to tighten. Finial Cap Roof Metal Ring Bulb Long Nipple Glass Shade Post Cup
