Download Roberts 10-60 Instructions / Assembly

SET UP
1. Installation of the Cutter
Install the cross bar to the cutter
base with provided bolt as
shown.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
2. Installation of the Cutter
Insert the handle to the base and
install the rear base to the front
base with provided screws as
shown.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
3. Working Table
Install the working table as
shown.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
-2-