Download SPT SD-9252SS Installation Guide

choose C and D.
Installation Preparation
UNIT DIMENSIONS
18"
DRAIN CONNECTIONS
The type of drain installation depends on the answers to
the following questions:
• Is air gap required by local codes and ordinances?
• Will waste tee or disposer connection be less than 18”
above the floor?
If both answers are YES, use method A or B. Otherwise
choose C or D.
A) air gap with waste tee
23"
DEPTH£23"(580mm)
WIDTH£18"(450mm)
33"~35"
HEIGHT£33"~35"
(840~890mm)
Figure 1
PREPARE THE LOCATION
The dishwasher should be installed near a sink for
water supply connection and proper drainage.
Figure 4
B) air gap with disposer
A build-in dishwasher must be fully enclosed on
the top, sides and back, and must not support any
part of the enclosure.
Area of Pipe or wires
Min. 24"
33 " 35-1/2 "
Underside of
Countertop to Floor
Figure 5
Area of Plumbing and
Electric Service
C) waste tee
6"
Min. 18"
Floor must be Even
With Room Floor
18"
Figure 2
Min.
DEPTH£24"(610mm)
WIDTH£18"(460mm)
HEIGHT£33"~35-1/2"(840~900mm)
CORNER INSTALLATION
When installed into a corner,
allow 2” minimum clearance
between dishwasher and
adjacent cabinet, wall or
other appliances. Allow 22"
clearance from the front
of the dishwasher for door
opening.
Minimum Clearance 2"
Figure 6
D) disposer
18"
Min.
22"
Figure 3
Figure 7
2