Download Sharp SD-AS10 User's Manual

General control
Setting the clock
SD-AS10
By setting the unit to the correct time, you can use it not only as a clock but also for
timer playback.
1
2
Turn on the unit, and press the TIMER/SLEEP/CLOCK button.
3
Press the or button to adjust the
year and then press the ENTER button.
Main unit operation:
Press the VOLUME UP button to increase the volume
and the VOLUME DOWN button for decreasing.
Remote control operation:
Press the VOL + button to increase the volume and
the VOL - button for decreasing.
0
1
2 ... 38
39
40
" Muting
The volume is muted temporarily when pressing the
MUTE button.
! Press again to restore the volume.
! The mute status is canceled when you adjust the
volume.
" To change the display brightness (2 levels)
Set the MODE 1/MODE 2 switch to MODE 2 and hold down the DISPLAY (-DIMMER)
button for 3 seconds or more.
Each time you press, brightness changes.
Dimmed
(*)
Brightened
Set "Month", "Date", "Hour" and "Minute"
in the same way.
! The 12-hour display will appear.
(AM 12:00 - PM 11:59)
! The time disappears after approx. 2 seconds.
To confirm the time display:
Set the MODE 1/MODE 2 switch to
MODE 2 and hold down the DISPLAY (-DIMMER) button for 3 seconds or more.
The time display will appear for
about 5 seconds.
[When the power is on]
Press the TIMER/SLEEP/CLOCK
button.
Within 10 seconds, press the or
button to select the time.
The time display will appear for
about 10 seconds.
Month Date Year
Hour Minute
Preparation for Use
" Volume control
- General control / Setting the clock -
Within 10 seconds, press the or
button to select the date and time indicator and then press the ENTER
button.
Note:
Unplugging the unit or power failure
will clear the clock setting.
Readjust the clock.
(*) After approx. 5 seconds of DVD playback, the display dims and the original brightness returns when you stop playback. The brightness remains unchanged during
playback of other media.
21