Download Quantum L200 User's Guide
Transcript
Chapter 2 Installing the Library Running the Power-on Self-test Running the Power-on Self-test 2 Run the power-on self-test (POST) to verify proper system installation. Turn on the library using the power switch on the back of the library. The POST runs automatically. The following message is displayed: PowerStor POST Table 1 lists the tests that are run during POST along with the OCP pass or error messages associated with these tests. Table 1 POST Pass/ Error Messages POST Test (Description) Messages Pass Error PowerStor POST 1 EDC POST Error in ROM EDC PowerStor POST 2 Micro RAM POST Error in Micro RAM UART (QUART test) PowerStor POST 3 UART POST Error in UART Other PowerStor POST 4 Other POST Error in Other ROM EDC (flash ROM EDC) Micro RAM (microprocessor local RAM test) Next the drive and the library are initialized. If the optional bar code reader is present (and the bar code enable mode is set), the cartridge bar code labels are read. The OCP buttons are not active until the Library Idle message is displayed on the library OCP. The following messages are displayed: Library INIT Library Idle 18 Quantum|ATL PowerStor L200 Series Library User’s Guide