Download NEC N8406-023 Command Reference Guide

802.1x Port configuration
Command: /cfg/l2/8021x/port <port number>
[802.1x Port Configuration Menu]
mode
- Set access control mode
qtperiod - Set EAP-Request/Identity quiet time interval
txperiod - Set EAP-Request/Identity retransmission timeout
suptmout - Set EAP-Request retransmission timeout
svrtmout - Set server authentication request timeout
maxreq
- Set max number of EAP-Request retransmissions
raperiod - Set reauthentication time interval
reauth
- Set reauthentication status to on or off
default - Restore default 802.1x configuration
global
- Apply current global 802.1x configuration to this port
cur
- Display current 802.1x configuration
The 802.1x port menu allows you to configure parameters that affect the selected port in the switch. These settings
override the global 802.1x parameters.
The following table describes the 802.1x Port Configuration Menu options.
Table 106 802.1x Port Configuration Menu options
Command
Description
mode forceunauth|auto|force-auth
Sets the type of access control for the port:
force-unauth - the port is unauthorized unconditionally.
auto - the port is unauthorized until it is successfully authorized by the
RADIUS server.
force-auth - the port is authorized unconditionally, allowing all traffic.
The default value is force-auth.
qtperiod <0-65535>
Sets the time, in seconds, the authenticator waits before transmitting an EAPRequest/ Identity frame to the supplicant (client) after an authentication failure
in the previous round of authentication. The default value is 60 seconds.
txperiod <1-65535>
Sets the time, in seconds, the authenticator waits for an EAPResponse/Identity frame from the supplicant (client) before retransmitting an
EAP-Request/Identity frame. The default value is 30 seconds.
suptmout <1-65535>
Sets the time, in seconds, the authenticator waits for an EAP-Response
packet from the supplicant (client) before retransmitting the EAP-Request
packet to the authentication server. The default value is 30 seconds.
svrtmout <1-65535>
Sets the time, in seconds, the authenticator waits for a response from the
RADIUS server before declaring an authentication timeout. The default value
is 30 seconds.
The time interval between transmissions of the RADIUS Access-Request
packet containing the supplicant‘s (client‘s) EAP-Response packet is
determined by the current setting of /cfg/sys/radius/timeout
(default is 3 seconds).
maxreq <1-10>
Sets the maximum number of times the authenticator retransmits an EAPRequest packet to the supplicant (client). The default value is 2.
raperiod <1-604800>
Sets the time, in seconds, the authenticator waits before re-authenticating a
supplicant (client) when periodic re-authentication is enabled. The default
value is 3600 seconds.
reauth on|off
Sets the re-authentication status to on or off. The default value is off.
default
Resets the port 802.1x parameters to their default values.
global
Applies the global 802.1x parameters to this port.
cur
Displays current port 802.1x parameters.
N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS)
106