Transcript
[ instruction INSTRUCTIONS FOR USE WITH READ AND FOR AITACHING LYTESPOT” LYTESPAN@ TRACK LYTESPAN@ TRACK UNDERSTAND SYSTEMS THESE SHEET NO. IS:6280AZ TO R0490 ONLY. INSTRUCTIONS BEFORE INSTALLING FIXTURE. This fixture is intended for installation in accordance with the National Code and local regulations. assure full compliance with local codes and regulations, check with your local electrical inspector installation. To prevent electrical shock, turn off electricity at fuse box before proceeding. Retain these instructions for maintenance reference. INSTRUCTIONS 1. Insert FOR AITACHING into LYTESPAN TRACK 2. Rotate FITTING 90° clockwise 3. Rotate FITTING until 4. To remove: depress LOCKING LOCKING LYTESPOT@ (see Fig. 1). LOCKING > TO SINGLE CIRCUIT TRACK To before SYSTEM LEVER must be on the same side of track as BEAD. (see Fig. 2). LEVER snaps LEVER, then and locks rotate in place (see Fig. 3). FITTING 90° counterclockwise. LYTESPAN BEAD ITTING LOCKING > FIG. 1 INSTRUCTIONS FOR CONVERTING LYTESPOT@ Attachment FITTING OPERATE ON 2 CIRCUIT TRACK FIG. 2 FIG. 3 t!RASS CONTACT TO See Fig. 4. BRASS CONTACT line indicates track system. position can be raised or lowered. Broken for 1 circuit or lower circuit of 2 circuit To convert attachment FITTING for upper circuit of 2 circuit track, raise BRASS CONTACT to high position by lifting CONTACT as high as stop permits and CONTACT clicks into place. LOCKING LEVER ~@ FIG. 4
