Download Graco 3A2894F User's Manual

Transcript
Installation
3. Install the Boom Base onto
the Machine Base.
5. Install the Front Boom Arm
onto the Boom Base.
Slide the boom base into the machine base mast.
Torque all fasteners to 24 ft-lb (33 N•m).
(3) Places
6. Install the Fluid Plate onto the
Front Boom Arm.
NOTICE
4. Assemble the Hose Clamps
onto the Front Boom Arm.
Hand tighten all hose clamps.
NOTE: Refer to steps 8 and 10 for visual clarity of hose
clamp placement.
Injury may occur if the fluid plate is lifted by only one
person. Use a hoist, multiple people, or remove the
fluid regulators prior to installation.
a. Torque the fluid plate fasteners to 24 ft-lb
(33 N•m).
b.
Install the fluid regulators if removed for installation.
Resin Hose Clamp
Calibration check only
3A2894F
23