Download Avaya Using Technician Interface Software User's Manual

Using Technician Interface Software
Parameter:
Attribute Name:
Maximum Hosts
wfSyslogMaxHosts
Attribute Number:
4
Default:
5
Range:
Function:
Specifies the maximum number of remote hosts considered “active” and
able to receive messages from the Syslog service on the router. The
number includes Syslog hosts configured to receive time-sequenced
messages, as well as hosts configured to receive messages
nonsequentially.
Instructions:
Enter the maximum number of active hosts allowed to receive messages
from Syslog on the router. The actual number of entries in the host table
can exceed the value of wfSyslogMaxHosts, but Syslog will forward
messages only to the first “n” active hosts, where n equals the current
setting of wfSyslogMaxHosts. Increasing the value of
wfSyslogMaxHosts increases the overhead processing requirements for
Syslog on the router.
Command:
MIB Object ID:
Parameter:
Attribute Name:
Attribute Number:
Default:
Range:
set wfSyslog.wfSyslogMaxHosts.0
<1 - 10>
1.3.6.1.4.1.18.3.3.2.15.1.4
Log Poll Timer
WfSyslogPollTimer
5
5 seconds
5 to 610000
Function:
Determines the amount of time Syslog waits before initiating another
cycle to poll all slots for event messages logged since the previous polling
cycle.
Instructions:
Enter the number of seconds that you want Syslog to wait between polling
cycles.
Command:
MIB Object ID:
C-32
1 to 10
set wfSyslog.wfSyslogPollTimer.0
<5 - 610000>
1.3.6.1.4.1.18.3.3.2.15.1.5
117381-A Rev. A