Download Avaya Using Technician Interface Software User's Manual
Transcript
Using Syslog Messaging to Monitor Router Managing Syslog on a Router Once you finish configuring Syslog on a router, you may occasionally need to • Disable or re-enable the entire Syslog entity on the router. (Refer in this section to “Disabling or Re-enabling Syslog on the Router.”) • Disable or re-enable a Syslog host or filter on the router. (Refer in this section to “Disabling or Re-enabling Syslog Hosts or Filters.”) • Delete remote hosts or entity filters from the current Syslog configuration. (Refer in this section to “Deleting Remote Hosts or Entity Filters from the Syslog Configuration.”) • Delete Syslog from the router. (Refer in this section to “Deleting Syslog from the Router.”) Disabling or Re-enabling Syslog on the Router You can, if necessary, disable the Syslog service anytime after enabling it on a router. Enter the following command line to disable Syslog: $: set wfSyslog.wfSyslogDisable.0 2;commit Disabling Syslog on the router • Transitions all Syslog hosts and their filters to an INACTIVE operational state in the router configuration • Halts all message forwarding from Syslog to any Syslog hosts configured on the router You can also re-enable Syslog after disabling it on a router. Enter the following command line to re-enable Syslog: $: set wfSyslog.wfSyslogDisable.0 1;commit Re-enabling Syslog on the router 114088 Rev. A • Transitions Syslog hosts and their filters to an ACTIVE operational state in the router configuration. (Only n Syslog host entries transition to the ACTIVE state, where n = the value of wfSyslogMaxHosts.) • Resumes all message forwarding from Syslog to Syslog hosts configured on the router. (Syslog forwards messages to n hosts only, where n = the value of wfSyslogMaxHosts.) C-23