Download Avaya Configuring DLSw Services (308622-14.20 Rev 00) User's Manual

Configuring DLSw Services
canureach-timer-2 <canureach_timer_2>
canureach_timer_2 specifies the time interval (in seconds) after which the router
sends a CANUREACH message to the remote DLSw peer to establish a session.
This parameter becomes active when the canureach-timer setting expires. The
values are 0 to 3600. The default is 30.
destination-mac <dest_mac>
dest_mac is the token ring or Ethernet host that the local device will reach using
SDLC services. The value is any standard 12-digit hexadecimal MSB token ring
MAC address.
destination-sap <dest_sap>
dest_sap is the token ring or Ethernet host that the local device will reach using
SDLC services. The values are 0x01 to 0xFE. The default is 0x4.
idblock <idblock>
idblock is the block number, which must match the host’s IDBLOCK value that
identifies incoming connection requests. This parameter is used with the pu-type,
idnum, and xid-format parameters to determine the station exchange identification
(XID) value. The block number is any 3-digit hexadecimal value.
idnum <idnum>
idnum is the ID number, which must match the host’s IDNUM value that identifies
incoming connection requests. This parameter is used with the pu-type, idblock,
and xid-format parameters to determine the station XID value. The ID number is
any 5-digit hexadecimal value from 00000 to FFFFF.
link-station-address <link_station_addr>
link_station_addr is the address of the link station. This value must match the
polling address defined in the SDLC-attached device. The value is any
hexadecimal link station address from 0x01 to 0xFE.
link-station-retries <link_station_retries>
link_station_retries is the maximum number of times that a connect request is sent
to the local SDLC device to establish a session. The values are 0 to 4294967295.
The default is 4294967295.
4-30
308622-14.20 Rev 00