Download EC Line EC-2D bar code reader

SNAPSHOT MODE TIMEOUT
This parameter sets the amount of time the decoder remains in Snapshot
Mode. The decoder exits Snapshot Mode upon a trigger event, or when the
Snapshot Mode Timeout elapses. To set this timeout value, scan the bar code
below followed by a bar code from Appendix D, Numeric Bar Codes. The
default value is 0 which represents 30 seconds; values increment by 30. For
example, 1 = 60 seconds, 2 = 90 seconds, etc.
Snapshot Mode Timeout
SNAPSHOT AIMING PATTERN
Select Enable Snapshot Aiming Pattern to project the aiming pattern when in
Snapshot Mode, or Disable Snapshot Aiming Pattern to turn the aiming pattern
off.
< Enable Snapshot Aiming Pattern >
Disable Snapshot Aiming Pattern
20