Download Infocus IN5144a
Transcript
Troubleshooting Problems that can be easily mistaken for machine defects Before assuming that the projector needs repair, review the following troubleshooting tips: Situation Troubleshooting tips The electrical power cord is unplugged. Connect the power cord correctly. The main power source was interrupted (for example a power outage (blackout), etc.). Disconnect the power plug from the power outlet, and allow the projector to cool down at least 10 minutes, then Power does not turn the power on again. come on. Either there is no lamp and/or lamp cover, or one of these has not been securely fastened. Turn the power off and disconnect the power plug from the power outlet, and allow the projector to cool down at least 45 minutes. After the projector has cooled down sufficiently, verify the lamp and lamp cover are securely attached, and then turn the power on again. The signal cables are not correctly connected. Correctly connect the connection cables. No sounds or pictures are outputted. 16 16 108 10 ~ 14 Signal source does not correctly work. Set up the signal source device correctly by referring to the source device manual. – The input changeover settings are mismatched. Select the input signal, and correct the settings. 26 AV MUTE function is working. Press AV MUTE button on the remote control. 25 The USB TYPE B port is the selected picture input source even if MOUSE is selected for USB TYPE B. Set USB TYPE B to USB DISPLAY in the OPTION menu to project the picture input to the port. Otherwise select a different port for picture input. 67 The USB TYPE B port is not recognized as an input port because of electrical noise. Temporarily set USB TYPE B to MOUSE in the OPTION menu, and then change it back to USB DISPLAY, so the projector recognizes the USB TYPE B port as an input port. 67 (continued on next page) 118 Reference page