Download Infocus IN5144a
Transcript
Troubleshooting Problems that can be easily mistaken for machine defects (continued) Situation Troubleshooting tips Reference page NETWORK BRIDGE function does not work The NETWORK BRIDGE function is turned off. Set COMMUNICATION TYPE to NETWORK BRIDGE in the OPTION - SERVICE - COMMUNICATION menu. 72 The SAVING function is working. Set STANDBY MODE to NORMAL in the SETUP menu. 56 Schedule function does not work When the projector is connected to the network, it powers off and on as described below. Powers off POWER indicator blinks orange several times Goes into standby mode The internal clock has been reset. If the projector is in SAVING mode and the projector is turned off (or AC power is turned off), the current date and time setting has been reset. Check the DATE AND TIME settings for WIRELESS SETUP or WIRED SETUP in the NETWORK menu. 78, 82 Disconnect the LAN cable and check that the projector is working properly. If this situation occurs after connecting to the network, there may be a loop between two Ethernet switching hubs within the network, as explained below. -There are two or more Ethernet switching hubs in the network. - Two of the hubs are connected twice by LAN cables. - This double connection forms a loop between the two hubs. Such a loop may have an adverse effect on the projector as well as other network devices. Check the network connection and remove the loop by disconnecting the LAN cables so that there is only one connecting cable between the two hubs. NOTE • Although bright or dark spots may appear on the screen, this is a unique characteristic of liquid crystal displays, and it does not constitute or imply a machine defect. 122 –