Download Gioteck VX-1
Transcript
VX-1 QUICK SETUP 1 2 3 4 5 6 1. Connect the VX-1 to your console via its charging lead. 2. Insert the usb dongle into a usb port on the console. 3.The LED on the dongle will flash quickly (slow flashing is receiving mode not pairing mode). 4. Immediately press the home button on your controller. 5.All the LEDs on the controller will flash, and after a short time one (or two) will remain solid. 6.Immediately disconnect the charging lead from the controller and the LEDs will flash again. 7. Repeat steps 4 & 5. (Sometimes pushing the home button again will speed up this process. If the controller fails to respond, repeat the process but make sure that you disconnect the dongle and reinsert.) 8.To add multiple controllers (up to 7) or assign your controller to a different port go to: Accessory settings > Reassign controller. Important Notices: • Make sure that the battery is fully charged before first use. • For the first few weeks your controller may need more frequent and longer periods on charge. • Use of the vibration feature will shorten the gaming time. • Resetting your controller If your controller loses connection with its dongle and will not pair, take a small pointed object and insert it into the hole found on the back of the controller. Pushing down on the button inside will reset the controller. Remove the dongle from the PS3 and switch off the console, remove the PS3’s power cord from the electrical socket, wait 15 seconds then plug in and turn on the console. Then follow the pairing instructions. RESET