Transcript
ADDONICS TECHNOLOGIES ADDONICS TECHNOLOGIES Model: AD2U3EXC34 Model: AD2U3EXC34 ExpressCard 34 form factor (34/54 slot bracket included) ExpressCard 34 form factor (34/54 slot bracket included) Slot bracket to fit into 54mm slot Two USB 3.0 ports Built-in 5V DC jack connector required for certain USB buspowered devices Slot bracket to fit into 54mm slot Two USB 3.0 ports Built-in 5V DC jack connector required for certain USB buspowered devices Software Installation: Software Installation: Adding the USB3.0 ExpressCard to an existing Windows system Adding the USB3.0 ExpressCard to an existing Windows system Note: Install NEC driver first by running the NECEL-USB3.0-Host-Driver-10170setup from the CD that came with your package before installing the host controller. A. From the CD start-up menu select SATA Adapters. Select Model #AD2U3EXC34. B. Install the NECEL-USB3.0-Host-Driver-10170-setup C. After driver installation, it is recommended to shutdown your system. Note: Install NEC driver first by running the NECEL-USB3.0-Host-Driver-10170setup from the CD that came with your package before installing the host controller. D. From the CD start-up menu select SATA Adapters. Select Model #AD2U3EXC34. E. Install the NECEL-USB3.0-Host-Driver-10170-setup F. After driver installation, it is recommended to shutdown your system. 1. 1. 2. 3. Turn computer ON. Insert card to ExpressCard slot. When Windows boots up, the “Found New Hardware Wizard” pops on the screen and the PCI Device is identified. Wait while the wizard installs the software… After driver installation, it is recommended to restart your system. 2. 3. Turn computer ON. Insert card to ExpressCard slot. When Windows boots up, the “Found New Hardware Wizard” pops on the screen and the PCI Device is identified. Wait while the wizard installs the software… After driver installation, it is recommended to restart your system. Confirming USB3.0 Driver Installation 1. Right click the My Computer icon and select Manage. 2. Click Device Manager in the Menu Tree. 3. Click the “+” sign in front of Universal Serial Bus Controllers. You should see NEC Electronics USB3.0 Host Controller NEC Electronics USB3.0 Root Hub. Confirming USB3.0 Driver Installation 1. Right click the My Computer icon and select Manage. 2. Click Device Manager in the Menu Tree. 3. Click the “+” sign in front of Universal Serial Bus Controllers. You should see NEC Electronics USB3.0 Host Controller NEC Electronics USB3.0 Root Hub. TECHNICAL SUPPORT (8:30 am to 6:00 pm PST) Phone: 408 453-6212 Email: http://www.addonics.com/support/query/ TECHNICAL SUPPORT (8:30 am to 6:00 pm PST) Phone: 408 453-6212 Email: http://www.addonics.com/support/query/