Download Vision TC2-CTL2 remote control

ENGLISH
PLACE OF INSTALLATION
Avoid installing your unit under the following conditions:
• Moist or humid places
• Places exposed to direct sunlight or close to heating equipment
• Extremely cold locations
• Places subject to excessive vibration or dust
• Poorly ventilated places
BATTERY LIFE
This product uses a 3V Lithium CR2450 battery for long life. The battery is housed in
a sealed compartment and should remain dry. If the product is installed in a humid
climate you should check the battery every six months to make sure it is not damp or
rusty.
An optional mains-power supply is available if you prefer to run this product from
mains power. Alternately this device can share a power supply with the Techconnect2
Amplifier2 product.
LIMITATIONS OF PRODUCT
This product has been tested with a wide range of data projectors, flat panel screens,
amplifiers, and projection screens. IR standards vary so we cannot guarantee this
control module will control all available products on the market. We highly recommend
testing this product with all equipment to be controlled before using this product for
large projects. If you do have problems please let us know so that we can improve this
product.
PACKAGING
Save all packing material. It is essential for shipping in the event the unit ever needs
repair.
IF ORIGINAL PACKAGING IS NOT USED TO RETURN THE UNIT TO THE SERVICE CENTRE,
DAMAGE IN TRANSIT WILL NOT BE COVERED BY WARRANTY.
2