Download SUPERWORKSTATION 7045A-3 USER`S MANUAL

Preface
Preface
About This Manual
This manual is written for professional system integrators and PC technicians. It
provides information for the installation and use of the SuperWorkstation 7045A3. Installation and maintainance should be performed by experienced technicians
only.
The SuperWorkstation 7045A-3 is a high-end, dual processor workstation based on
the SC743TQ-645 4U tower/rackmount chassis and the X7DA3, a dual processor
serverboard that supports single or dual Intel® XeonTM 5100/5000 series processors
at a Front Side (System) Bus speed of 1333/1066/667 MHz and up to 32 GB of
ECC FBD DDR2-667/533 SDRAM.
Manual Organization
Chapter 1: Introduction
The first chapter provides a checklist of the main components included with the
server system and describes the main features of the SUPER X7DA3 serverboard
and the SC743TQ-645 chassis, which comprise the SuperWorkstation 7045A-3.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the system into a rack and
check out the server configuration prior to powering up the system. If your server
was ordered without processor and memory components, this chapter will refer you
to the appropriate sections of the manual for their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions and
information provided by the control panel on the chassis as well as other LEDs
located throughout the system.
iii