Download Sun Netra CP3240 Switch Userճ Guide

Quick Startup IP Address
To view the network parameters the operator can access the device by the following
three methods.
■
Simple Network Management Protocol - SNMP
■
Telnet
■
Web Browser
Note – Helpful Hint: The user should do a ‘copy system:running-config
nvram:startup-config’ after configuring the network parameters so that the
configurations are not lost.
TABLE 1-4
Quick Startup IP Address
Command
Details
show network
Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 0.0.0.0
Subnet Mask - IP Subnet Mask for the interface
Default is 0.0.0.0
Default Gateway - The default Gateway for this interface
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC Address used
for in-band connectivity
Locally Administered MAC Address - Can be configured to
allow a locally administered MAC address
MAC Address Type - Specifies which MAC address should be
used for in-band connectivity
Network Configurations Protocol Current - Indicates which
network protocol is being used
Default is none
Management VLAN Id - Specifies VLAN id
Web Mode - Indicates whether HTTP/Web is enabled
Java Mode - Indicates whether java mode is enabled.
(User EXEC Mode)
network parms
<ipaddr>
<netmask>
[gateway]
(Privileged EXEC
Mode)
12
Sets the IP Address, subnet mask, and gateway of the router.
The IP Address and the gateway must be on the same subnet.
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
Gateway Address range from 0.0.0.0 to 255.255.255.255
Sun Netra CP3240 Switch User’s Guide • April 2009