Download INSTALLATION INSTRUCTIONS
Transcript
I N T E G R AT E D I N S T A L L A T I O N I N S T R U C T I O N S PA N E L I N S T A L L A T I O N If you have questions, contact your Sub-Zero dealer or cabinet supplier. Additional panel information can be found in the Sub-Zero Design Guide. PA N E L B R A C K E T P O S I T I O N I N G 23 7/8"* (606) FOR 27" WIDE UNITS 32 7/8"* (835) FOR 36" WIDE UNITS 17/16"* (37) D O O R PA N E L I N S TA L L AT I O N Remove the two pieces of mounting hardware attached to the front of the door and set aside. Place the door panel lying face down on a protected surface to ensure that the front is not scratched or damaged. RH DOOR SWING LH DOOR SWING Position the plastic template provided flush with the lower edge of the door. Be sure you are following the exact location for the righthand (RH) or left-hand (LH) door position. Refer to illustration 12 on page 14. IMPORTANT NOTE: The template has two usable sides, one side for the door and one for the drawers. Make sure you use the proper holes and side. Remember you are viewing the door panel from the back side in illustration 12 on page 14. Once you have located the proper position for the bracket, mark the pilot holes, remove the template and drill pilot holes for mounting the bracket. It is best to start with a few holes, position the bracket, drill the remaining pilot holes and then secure the mounting bracket with the #8 x 1/2" screws provided. Illustration 13 shows the mounting hardware location for door and drawer panels. IMPORTANT NOTE: Dimensions in illustration 13 are based on a 1/8" (3) reveal. A reveal of up to 1/4" (6) is possible, but panel dimensions need to be adjusted accordingly. 5 3/16" 5 5/16" (135) (132) 11/4" 11 5/16" (32) (287) 11/4" 8 7/16" (32) (214) VIEW FROM BACK OF PANELS *DIMENSIONS MAY VARY Illus. 13 Exercise caution when drilling holes for mounting hardware. This is especially critical with inset panels. Dimensions in parentheses are in millimeters unless otherwise specified. 15