Download uPrint User Guide

Operation
41
Removing support material
uPrint uses soluble support material, designed to allow you to simply wash it away. Your part is left with a
smooth and clean finish with the fine details intact. The soluble support material can be removed by hand
with relative ease, but is designed to be dissolved from your parts for hands free finishing.
Warning:
Support material is sharp, wear safety glasses and gloves when removing
support material.
Refer to the SST process guide for details regarding the removal of soluble support material. A copy of the
SST Process Guide can be found at http://www.uPrintDimension.com
Emptying the purge bucket
Empty the purge bucket after each build. This will ensure the purge bucket does not over fill which can
cause part quality issues or damage to the printer.
WARNING
Wear gloves when emptying the purge bucket.
1.
With a gloved hand, lift up on the purge bucket and pull it off of the 2 mounts. See Figure 26
Figure 26: Emptying the purge bucket
Purge Bucket Mounts
Purge Bucket
Stratasys Document Number 206465-0001