Download uPrint User Guide

Setup
32
Loading material to the head for the dual material bays
1.
Once the material carriers have been added to the material bays, press Load... Select Materials will
now be displayed.
2. Select the material bays that you want to be active, or loaded to the head. Select Next Model for the
next model bay, this will toggle between M1 and M2, or Next Support for the next support bay, this will
toggle between S1 and S2. A carrot will be placed next to the material bay that will be activated.
3. When the material bays have been selected, you can now press Load Selected. The display will show
Loading and the model material bay that has been selected. After the model material has been loaded
to the head, the display will show Loading and the support material bay that has been selected.
4. After the selected material bays have been loaded to the head, the display will show Preparing and
the inactive model material bay. This will repeat for the inactive support material bay. An asterisk will be
placed next to the model and support material bays that are active.
Note:
It can take up to 5 minutes for the printer to load the material to
the head.
5. When the material has been loaded to the head and the secondary material bays have been prepared,
press Done... the display will show Wait for Part or Ready to Build (if a part is in the queue) and will
also show the amount of material remaining in both model and both support carriers.
Building a Test Part
Factory test parts have been pre-loaded into the operating system of your printer. To familiarize yourself
with the system, it is recommended that you build one of these test parts before attempting to build one of
your own files.
Once the printer has reached Idle, material has been loaded and a modeling base has been installed, you
can build a test part with the printer.
1.
From the display panel press Maintenance.
2. Press System.
3. Press Test Parts and select the sample wrench.
•
The printer will automatically start to print the test part.
When the part is finished, follow the steps under “Remove a completed part from the printer:” on page 40.
Stratasys Document Number 206465-0001