Download HMD-A240

HMD-A240
SECTION 1: DISASSEMBLY
1-1. CABINET REMOVAL
2
1 Remove (4) Screws (+BVTP 4 x 16)
2 Release top claws - Insert the tip of a ßathead
screwdriver approximately 0.25" to unlock the
claw. Gently lift up and then back to remove
the cabinet.
2
1
1-2. SERVICE POSITION
1 Gently wiggle the A board back and forth to unplug
it from the Neck Assembly.
1
2 Remove all necessary connections and rotate the
D Board and rest it on its side to expose the bottom.
Be sure to reconnect all wires.
3 Fabricate a temporary ground wire with a male
stakon connector on one end and an alligator clip
on the other.
4 Reconnect ground as shown below.
2
4
—7—