Download Manual

SERVICE RECORD
MAINTENANCE INSTRUCTIONS
For proper and safe operation keep furnace and
furnace area clean. At regular intervals turn
control valve to off, let cool and clean inside
control compartment and under heater. To clean
front panel use only a damp cloth, do not use
any kind of solvent or cleaning fluid that could
leave a residue or invisible coating that would
burn or give off fumes when furnace is turned
on.
Have the furnace checked, cleaned, and repaired
by a qualified service technician. Check venting
system, pilot, and burner operation prior to use each
year.
Follow a regular service and maintenance
schedule for safe and efficient operation.
Do not obstruct combustion and ventilation air.
Examine the venting system as a routine part of
the safety performance check on an annual basis.
If the air intake tube or the exhaust tube is
removed, follow Step 3 of the installation section
for re-assembly. Be sure to check gaskets and
replace if there is any sign of damage.
If the heat exchanger is removed, check the heat
exchanger intake gasket and replace if there is
any sign of damage. Be sure the gasket is in
place when the heat exchanger is replaced.
Failure to replace any gasket that has been
damaged may result in property damage, personal
injury or loss of life.
WARNING
THIS IS A GAS-FIRED APPLIANCE. KEEP
THE AREA CLEAR OF GASOLINE AND
OTHER FLAMMABLE VAPORS AND
LIQUIDS. ALL COMBUSTIBLE MATERIAL
MUST BE KEPT CLEAR OF THIS AREA TO
AVOID FIRE OR EXPLOSION.
Page 21