Download Manual - Avaya Support
Transcript
230739i3bk.book Page 26 Thursday, August 12, 1999 12:28 PM Installing the Designation Card Use the button designation card to write the telephone number, extension, name, or feature that each call appearance/feature button can access. In order to help you match the designation cards with the call appearance/feature buttons on the telephone, the columns of button labels are marked with the 6400 Series multi-line telephone model with which the label can be used. Below the perforated bottom edge of each designation card is a telephone number card on which you can write your telephone number or extension. To label and install the designation card and telephone number card 1. Print the numbers/features on the button designation card that corresponds with the telephone you are using, and type or write your phone number or extension on the telephone number card (labeled Tel no.). 2. Crease the perforated edges of the cards you have filled out and then tear the button designation strips and the station number card along the perforations. 3. Place the button designation card and telephone number card under the plastic card cover on the telephone by doing the following: — — The transparent designation card cover is attached to the frame of the telephone by tabs on the top and bottom of the cover. Remove the cover by pulling the top tab forward and then lifting the bottom of the transparent cover from the telephone. Place the designation card(s) on the telephone and then replace the transparent cover over the card by inserting the tabs at the bottom and then pressing the top down until it clicks. Note: You can order additional designation cards in quantities of 25 cards and 100 cards per package. Use the following comcodes when you place your order. 25 sheets of designation and telephone number cards: Comcode: CC847984614 100 sheets of designation and telephone number cards: Comcode: CC847984622 26