Download Datamax M-Class 4208 Thermal Label Printer

Try this solution…
If experiencing this problem…
Examine the used ribbon for an image:
If there is an image on the used ribbon:
Verify that the ribbon was properly loaded per Section 3.4.
Nothing is printing (labels
advance normally, but no image is
printed):
If properly loaded, the wrong coating configuration was used. (To verify the
inked side, press the adhesive backing of a label against the ribbon surface. Ink
will only lift from the coated side of the ribbon.) Clean the printhead (see
Section 6.1); then replace the ribbon with the correct type for the printer,
Section 3.4.
If there is no image on the used ribbon:
• Print any Internal Test Label; non-display printers see Section 4.8, display
printers see Section 5.3. If an image printed, then check the protocol and port
settings for both the printer and host. These must match.
• The heat setting may be too low. Make an adjustment in the software program
or through the Front Panel.
• The
media/ribbon combination may be incorrect. Contact a Media
Representative.
• The printhead or printhead cable(s) may be loose; power ‘Off’ the printer then
reconnect.
• Ensure that the printer is at READY.
Nothing happens when trying to
print using a software program:
• Observe the Front Panel, if the READY light does not flash as you send the
format check the protocol and port settings between the printer and host.
• Ensure the interface cable meets the requirements found in Section 3.1.2.
M-Class
91