Download Enterasys BRIM A6DP (BRIM

The ELAN Properties Screen
6. Ensure that the MAX MTU Size field displays [1516]. If it does not,
press the SPACE bar until [1516] displays.
7. Use the arrow keys to highlight the LES ATM Address field.
8. Enter the LES ATM Address. Ensure that a valid ATM Address is
used.
9. Use the arrow keys to highlight the ADD/MODIFY command at the
bottom of the screen and press ENTER. The manually configured LEC
is now entered into the BRIM-A6DP LEC Index. Check the ELAN
Properties screen to verify that the ELAN became operational. For
information on the ELAN Properties screen proceed to Section 3.7.
3.7
THE ELAN PROPERTIES SCREEN
To access the ELAN Properties screen from the ATM Setup screen,
perform the following steps:
1. Use the arrow keys to highlight the ELAN Properties selection of the
ATM Setup screen.
2. Press ENTER; the ELAN Properties screen, Figure 3-5, displays.
ESX-1320 Local Management
Flash Image Version: XX.XX.XX
LEC PROPERTIES
LEC STATE:operational(7)
STATUS: active(1)
LEC Index: d
LEC ID: 3
LEC ATM ADDR: 0000000000000000000000000000000000000000
LECS ATM ADDR: 0000000000000000000000000000000000000000
LES ATM ADDR: 0000000000000000000000000000000000000000
BUS ATM ADDR: 0000000000000000000000000000000000000000
LECS Configuration Direct VCC:
LES Control Direct VCC:
LES Control Distribute VCC:
BUS Multicast Send VCC:
BUS Multicast Forward VCC:
:
NEXT
PREV
Figure 3-5
BRIM-A6DP User’s Guide
0, 0
0, 40
0,255
0, 41
0,253
EXIT
RETURN
The ELAN Properties Screen
3-15